180
Operation Swltcll
START/STOP Button
Lock Button •
Power Switch _1_
_ Power lamp
ShootingWhileWalchingTheL(DMonilor
Before the follo'Mng steps, perform step 1 (_T_ pg. 20).
ENTER RECORD-STANDBY MODE
Make sure the vJewfinder is pushed back in. Set the
Operation Switch to "D" or "[_". Then, set the
Power Switch to " _" while pressing down the
Lock Button.
Open the L(D monitor fully.
• The lens cover opens, the power lamp lights and the
camcorder enters the Record-Standby mode.
• The scene you are aimed at appears ill the LCD
monitor, with the word "PAUSE" superimposed
upon it.
START SHOOTING
Tilt the LC D mon kor upward/downward for best
viewability (_T* pg. 23) and press START/STOP.
, ,,REC_._,, appears ill the LCD monitor while recording
is in progress.
STOP RECORDING
Press START/STOP again to stop recording.
• The camcorder re-enters the Record-Standby mode.
NOTES:
• When you use the LCD monitor outdoor_ in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we rec_)mmend that y_>u use the viewfinder
(_ / pg. 2dA
• _ tutti the ta//y laml_ offduring recording, refer t_)
• F_;r other note_, ret_r to pg. 21.
Tally lamp
(lights while
recording is
in progress)
[__
To Next Page
Loading...
