PIN-UP
Pin-Up mode*
FRAME
snapshot mode
with frame*
FULL
snapshot mode
with no frame*
MULTI-4
Multi-Analyzer 4
To Record An Image With A Title/Frame...
.... refer to "Superii_posing A Title/Frame" (_T_ pg. 69).
To Remove The Shutter Sound...
.... when you don't want to hear tile shutter sound, set
BEEP/TALLY to "OFF" in the System Menu
(_ ,_ pg. _6 39). Tile sound is no longer hard from tile
speaker.
NOTES:
• Even if "MULTI-4" or "MULTI-_" is eny, a_ed, Snapsh_4
recording will be pertbrmed irl the FULL mode durin_
Digital Z_;om. However, the flash will riot fire.
• If Snapshot r¢cording is not possible, "PHOTO" blinks
when PHOTO (SNAPSHOT) is pressed.
• Ewn ifPr_;'4ram AE with special eflZct_ (_z _pg. 44, 4_; is
engaged, certairl modes of Pr_;gram AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
• If shooting is riot per_>rmed f_;r approx. 5 minutes when
tile Power Switch is set t_; "_]" arid power is slqJplied
fr_;m tile battery pack, the camcord_r shuts off aut_;mati-
call}, to save powec To perform shooting, agairl, close the
LCD monitor and r_-open it. When usin_ tile viewfind_r,
push back it in and pull it (>tit again,
• Motor Drive Mode (_ ,_pg. 32) is disabled when the
Power Switch is set to "[_ ".
• R> reduce tile Red-Eve effect of the subject's eyes when
tile flash fires, _ T" pg. _4.
• When a cable or headphone set is connected to the AV
OUT conrlector, tile shutter sound is not heard t}_;m the
speaker.
MULTI-9
Multi-Analyzer 9
* :There is the sound of a shutter closing.
To Next Page
Loading...
