Grip Adjustment
Power Switch
Diopter Adjustment
Control
Separate the Velcro strip,
Pass your right hand through the loop and grasp the
grip.
Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.
Viewfinder Adjustment
Set the Power Switch to “El” or “0” while
pressing
down the Lock Button located on the switch.
Pull out the viewfinder fully.
Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
Tripod Mounting
Align the screw on the tripod with the camera’s
mounting socket. Then tighten the screw.
*Some tripods are not equipped with studs.
CAUTION:
When attaching the camera to a tripod, extend its
legs to stabilize the camcorder. It is not advised to use
small sized tripods. This may cause damage to the
unit by falling over.
To Next Page
Loading...
Need help?
General
