Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from “OO:OO:OO”
(minute:second:frameL If recording starts from the end of a previously recorded scene, the time code
continues from the last time code number.
To perform Random Assemble Editing (Lr pg. 69 - 73), time code is necessary. If during recording a blank
portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time
code starts counting up again from “OO:OO:OO”. This means the camcorder may record the same time
codes as those existing in a previously recorded scene. To prevent this, perform “Recording From The
Middle of A Tape” below in the following cases;
*When shooting again after playing back a
recorded tape.
Display
Frames are not displayed
l When power shuts off during shooting.
during recording.
l When a tape is removed and re-inserted during
shooting.
Minutes
l When shooting using a partially recorded tape.
Seconds
l When shooting on a blank portion located
partway through the tape.
Frames
l When shooting again after shooting a scene
(30 frames = 1 second)
then opening/closing the cassette holder cover.
Recording From The Middle Of A Tape
1. Play back a tape or use Blank Search (or;l pg.
24)
to find the spot at which you want to start recording,
then engage the Still Playback mode (ID pg. 21).
2. Set the Power Switch to 0 0 “ or “0” while pressing down the Lock Button located on the switch, then
start recording.
NOTES:
l
The time code cannot be reset.
l
During fast-forwarding and rewinding, the time code indication does not move smoothly.
l
The time code is displayed only when “TIME CODE” is set to “ON” (w pg. 4 1, 42).
When a blank portion is recorded on a tape
Time code Time code
oo:oo:oo 05:43:21
Time code
oo:oo:oo
Tape
A
A A
Shooting start point Shooting stop point
Shooting start point
Proper recording
Time code
oo:oozoo
Time code
05:43:21
Time code
05:44:00
Tape
A
A A
Shooting start point Shooting start point
Shooting start point
To Next Page
Loading...
