Play/Pause Button (W/II)
Normal Playback
Rewind Button (44)
Fast-Forward Button (w)
l **- -
-- -
Stop Bhtton (W)
i
- VIDEO/DSC Switch
(CR-DVM75 only)
Power Switch
1 lock Button 1
Pow& Zoom
lever (Speaker
Speaker
Volume Control)
(VOL.)
Load a tape (= pg. 12)
Set the VIDEO/DSC Switch to “VIDEO” (GR-
DVM75 only), then set the Power Switch to “m”
while pressing down the Lock Button located on the
switch. To start playback, press )/II.
*To stop playback, press H.
l
Press 4 to rewind, or H to fast-forward the
tape during Stop mode.
To Control The Speaker Volume . . .
. . . .
slide the Power Zoom Lever (Speaker Volume
Control) (VOL.) towards “+” to turn up the volume,
or towards 11-“ to turn down the volume.
NOTES:
l
if Stop mode continues for 5 minutes when power is supplied
from a battery, the camcorder shuts off automatically. To turn
on again, set the Power Switch to “OFF”, then to “m “,
l
The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV (07 pg. 22,231.
l
You can a/so view the playback picture on the LCD monitor
with ir flioned over and oushed apainst the camera hod:
, I
l
LCD monitor/viewfinder indi&ions:
l
When power is supplied from a battery: the “a n
battery pack remaining power indicator is displayed.
When power is supplied from an AC outlet: “13 u
does not appear.
l
During Stop mode, none of the indications are displayed.
l
When a cable is connected to the AV connector, the
sound is not heard from the speaker.
Still Playback:
Pauses during playback.
1) Press )/II during playback.
2) To resume normal playback, press b/II again.
l
If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically
engaged. After 5 minutes in the Stop mode, the camcorder’s power is automatically turned
off.
l
When b/II is pressed, the image may not pause immediately while the camcorder stabilises the still image.
Shuttle Search:
Allows high-speed search in either direction.
1) Press m for forward or rH for reverse search during playback.
2) To resume normal playback, press b/II.
l
During playback, press and ho/d 44 or H The search continues as long as you hold the button.
Once you release it, normal playback resumes.
l
A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Frame-By-Frame Playback:
Allows frame-by-frame search.
1) Engage Still Playback.
2) Rotate MENU Wheel towards “+” for forward Frame-By-Frame Playback, or towards “-O for reverse
Frame-By-Frame Playback during Still Playback.
n
To resume normal playback, press b/II.
l
You can also use the provided remote control for Frame-By-Frame Playback (w pg. 64).
Playback Zoom and Playback Special Effects
Available only with the remote control (provided) (~1 pg. 64, 65).
To Next Page
Loading...
