EN
83
become unusable.
to clear. When it does, you
can resume using the
camcorder.
If the indication remains even
though you repeat the above
two or three times, please
consult your nearest JVC
dealer.
47. The charger indicator on the
camcorder does not light.
48. Picture does not appear on
the LCD monitor.
4%
l
The temperature of the battery
is extremely high/low.
l
Charging is difficult in places
subject to extremely high/low
temperatures.
48.
l
The viewfinder is pulled out.
l
The LCD monitor’s brightness
setting is too dark.
4%
l
To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C (50°F to 95°F)
b pg. 93).
48.
l
Push the viewfinder back in.
l
Adjust the brightness of the
LCD monitor @pg. 18).
l
If the monitor is tilted upward
180 degrees, open the
monitor fully (m pg. 18).
49. When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
49.
l
This is not a malfunction. 49.
l
By recording with “DIS”
activated (= pg. 39) this can
be avoided.
50. When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
50.
l
The DV cable was plugged/
50.
l
Turn the camcorder’s power
unplugged with power turned off and on again, then operate
on. it.
51. During transport, the lens
cover opens.
51.
51.
l
Do not subject the camcorder
to shock or excessive
vibration during transport.
l
Turn the camcorder on and
off. The lens cover closes.
52. The memory card cannot be
removed from the
camcorder.
52.
52.
l
Push in the memory card a
few more times (art pg. 14).
To Next Page
Loading...
