After Use
I
Turn off the camcorder.
battery pack a@.
Slide down and hold
OPEN/EJECT
in the
direction of the arrow, then pull the cassette
holder cover open until it locks. The cassette
holder opens automatically. Remove the
cassette.
Press “PUSH HERE” to close the cassette holder.
l Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
I
Shde down
BAlT. RELEASE
@ and remove the
Cassette holder
-
OPEN/EJECT Switch
Cleaning The Camcorder
Put the cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again
with a dry cloth.
Open the LCD monitor. Wipe gently with a soft
cloth. Be careful not to damage the monitor.
Close the LCD monitor.
To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
j
To clean the exterior, wipe gently with a soft
cloth.
1 Pull out the viewfinder fully.
Open the viewfinder cleaning hatch in the
direction of the arrow 0.
Insert a lens blower or soft cloth into the gap at
the side of the viewfinder and clean the interior
of the viewfinder with it 0.
#
Close the hatch until it locks in place and push
the viewfinder back in.
NOTES:
l
Avoid using strong cleaning agents such as benzine
or alcohol.
l
Cleaning should be done only after the battery
pack has been removed or other
power
units have
been disconnected.
l
Mould may form if the lens is left dirty
l
When using a cleaner or chemically treated cloth
refer to the cautions of each product
Hatch
- BATT. RELEASE Switch
lens blower
To Next Page
Loading...
