Indications Function
INSERT ERROR!
l
Appears if Insert Editing is attempted on a tape recorded in the LP
<CANNOT EDIT
ON A LP RECORDED
mode.
(= pg. 68)
TAPE>
*Appears if INSERT (0) on the remote control is pressed when the erase
:CHECK TAPE’S ERASE
protection tab is set to “SAVE”.
(e pg. 68)
PROTECTION TAB>
l
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
*Appears in the following cases when dubbing from a tape to a memory
card (as digital stills or video clips):
-when no memory card is loaded.
- when the memory card’s memory is full.
COPYING FAILED
-when the memory card is not formatted.
- when a copy-protected SD Memory Card is loaded.
(~7 pg. 6861)
*Appears in the following cases when dubbing still images or sound
effects stored in the memory card to a tape:
-when condensation occurs.
-when no tape is loaded.
- when the erase protection tab is set to “SAVE”.
-when a tape in another format is loaded.
-when the tape ends.
(= pg. 59)
Appears if a memory card is not loaded when SNAPSHOT is pressed
MEMORY CARD!
while the Power Switch is set to ” El ” or ” 0 v and the VIDEO/DSC
Switch is set to u m “.
(= pg. 26)
PLEASE
Appears when there is a problem with a memory card and its memory is
FORMAT
corrupt, or it has not been initialised. lnitialise the memory card.
(= pg. 36)
0 Appears when the Power Switch is set to ti m rr and the VIDEO/DSC
Switch is set to “m” if there are no image files stored in the memory card
NO FILES STORED
@Appears if there are no video clip files stored in the memory card when
the video clip mode is engaged by pressing the SELECT button.
l
Appears after a memory card is initialized.
Appears if there are no sound files stored in the memory card when the
NO SOUND FILES sound effect mode is engaged by pressing the SELECT button or
DSOUND PLAY is pressed during video recording.
Unsupported
file!
Appears when a file in a format other than MP3 for digital sound or DCF
for image is selected.
EOl - E06
The error indications (EOl - E06) show what type of malfunction has
UNIT IN SAFEGUARD
occured. When an error indication appears, the camcorder turns off
MODE REMOVE AND
automatically. Remove the power supply (battery, etc.) and wait a few
REATTACH BATTERY
minutes for the indication to clear. When it does, you can resume using
the camcorder. If the indication remains, consult your nearest JVC dealer.
Appears when the camcorder takes more than 60 seconds to recognize
CARD ERROR!
the loaded memory card. Remove the memory card once and insert it
again. Repeat these procedures until no indication appears. If the
indication still appears, the memory card is corrupted.
:HECK CARD’S WRITE
Appears when you attempt to shoot digital still images while a copy-
JROTECTION SWITCH
protected SD Memory Card is loaded.
To Next Page
Loading...
