EN 75
1
REMOVE POWER SUPPLY
Remove the battery pack or disconnect the AC
Charger Station (Z pg. 8 – 10).
2
CLEAN EXTERIOR
Wipe gently with a soft cloth.
•Put cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again
with a dry cloth.
3
CLEAN LENS
Blow it with a blower brush, then wipe gently
with lens cleaning paper.
4
PULL OUT VIEWFINDER
Pull out the viewfinder fully.
5
CLEAN VIEWFINDER
Slide the cover in the direction of the arrow 1.
Insert a lens blower or a soft cloth into the gap
at the bottom of the viewfinder and clean the
interior of the viewfinder with it 2.
AFTER USE
6
PUSH VIEWFINDER BACK IN
Slide the cover back to its original position and
push the viewfinder back in.
7
OPEN LCD MONITOR
Open the LCD monitor fully.
8
CLEAN LCD MONITOR
With soft cloth, gently wipe the LCD monitor
in a semicircular pattern. Avoid using too
much pressure as this will smear the monitor
screen, making it much more difficult to clean.
9
CLOSE LCD MONITOR
NOTES:
●
Avoid using strong cleaning agents such as
benzine or alcohol. This may damage the unit’s
body or cause malfunction.
●
When using a cleaner or chemically treated cloth
refer to the cautions of each product.
Cleaning The Camcorder
2
1
Battery cover
LCD monitor
Bottom of
viewfinder
Battery pack
Open switch
(BATTERY)
Gap
To Next Page
Loading...
