EN 25
1 Make sure all units are turned off.
2 Connect the camcorder to a TV or VCR as shown
in the illustration. (墌 pg. 24)
If using a VCR, go to step 3.
If not, go to step 4.
3 Connect the VCR output to the TV input,
referring to your VCR’s instruction manual.
4 Turn on the camcorder, the VCR and the TV.
5 Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
To choose whether or not the following displays
appear on the connected TV…
● Date/Time
Set “DATE/TIME” to “AUTO”, “ON” or “OFF”.
(墌 pg. 48)
Or, press DISPLAY on the remote control to turn
on/off the date indication.
● Time Code
Set “TIME CODE” to “ON” or “OFF”. (墌 pg. 48)
● Playback sound mode, tape speed and tape
running displays for video playback
Set “ON SCREEN” to “LCD” or “LCD/TV”.
(墌 pg. 48)
NOTES:
●
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the
battery pack. (墌 pg. 11)
● To monitor the picture and sound from the
camcorder without inserting a tape or memory
card, set the camcorder’s Power Switch to “
A” or
“M”, then set your TV to the appropriate input
mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
● If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
● While the S/AV/Editing cable is connected to the
S/AV connector, sound cannot be heard from the
speaker.
● If no image is displayed or no sound is heard from
the TV, set “S/AV INPUT” to “OFF” in VIDEO
Menu. (墌 pg. 51)
NOTE:
How to connect the S/AV/Editing cable...
● Insert the cable straight into the S/AV connector.
● To disconnect the S/AV/Editing cable, pull the cable straight out.
S/AV/Editing cable
(provided)
To S/AV connector
To Next Page
Loading...
