EasyManua.ls Logo

JVC GR-DVP9 - Built-In Clocks Rechargeable Lithium Battery; Date;Time Settings

JVC GR-DVP9
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 EN
Master Page: Left
The date/time is recorded onto the tape at all times,
but its display can be turned on or off during
playback. ( pg. 31, 41)
1 Set the Power Switch to M” while pressing down
the Lock Button located on the switch.
2 Open the LCD monitor fully, or pull out the
viewfinder fully.
3 Press MENU. The Menu
Screen appears.
4 Press + or to select
n DISPLAY”, and press
SET/SELECT. The CAMERA
DISPLAY Menu appears.
5 Press + or to select
“CLOCK ADJ.”, and press
SET/SELECT. The
parameter for “Month” is highlighted.
6 Press + or to input the
month, and press SET/
SELECT. Repeat to input
the day, year, hour and
minute.
7 Press + or to select
BRETURN”, and press
SET/SELECT twice. The Menu Screen closes.
Built-in Clock’s Rechargeable Lithium Battery
To store the date/time in memory, the clock’s
rechargeable lithium battery is integrated in the
camcorder. While the camcorder is connected to an
AC outlet using the AC Power Adapter/Charger, or
while the battery pack attached to the camcorder
continues to supply power, the clock’s rechargeable
lithium battery is always charged. However, if the
camcorder is not used for approx. 3 months, the
clock’s lithium battery will become discharged and
the date/time stored in memory will be lost. When
this occurs, first connect the camcorder to an AC
outlet using the AC Power Adapter/Charger for over
24 hours to charge the clock’s rechargeable lithium
battery. Then perform the date/time setting before
using the camcorder.
Note that the camcorder can be used without setting
the date/time.
NOTE:
Even if you select “CLOCK ADJ.”, if the parameter is
not highlighted, the camcorder’s internal clock
continues to operate. Once you move the highlight
bar to the first date/time parameter (month), the
clock stops. When you finish setting the minute and
press SET/SELECT, the date and time begin
operation from the date and time you have just set.
Date/Time Settings
Power Lamp
Power Switch
Lock Button
MENU Button
SET/SELECT Button
+, – Button
OF
HIDE
FA R ET
LADE
FA R
KC
.WDE
FA R
RNPE
C WI
RE
NDPE
W WI
WO
IDPE
S WI
E
ORPE
D WI
RO
PE
S WI
LL
W
B
B
O
I
L
O
C
R/F
DIPE WA
E
F
UTPE
S WI –RETH
LC
NRETUR
T/D
AUMET–/TI DA E OT
OFDEM– CO TI E
F
DE OK CL C 2 C
J AD .
3:5
LA
D
ASERA CM I
YP
V
5'0 3
0 PM
NCREON S E
NRETUR
OK
CL C 2
J
AD . 3:5
LA
D
ASERA CM
I Y
P
5'0 3
0 PM
DEC
GR-DVP9US.book Page 14 Wednesday, January 22, 2003 5:35 PM

Table of Contents

Related product manuals