To Next Page
C
Christopher BellSep 23, 2025
How to display time code on my JVC Camcorder?
- RrandallsamanthaSep 23, 2025
If the time code does not appear, it means that “TIME CODE” is set to “OFF”. Set “TIME CODE” to “ON.”
How to display time code on my JVC Camcorder?
If the time code does not appear, it means that “TIME CODE” is set to “OFF”. Set “TIME CODE” to “ON.”
What to do if the power/charge lamp on my JVC GR-DV700 does not light when charging?
If the power/charge lamp on the camcorder does not light when charging, it could be due to the battery temperature being extremely high or low, or charging is difficult in places subject to extremely high/ low temperatures. To protect the battery, it is recommended to charge it in places with a temperature of 10°C to 35°C.
What to do if my JVC GR-DV700 Camcorder does not operate when connected via the DV connector?
If the camcorder does not operate when connected via the DV connector, it might be because the DV cable was plugged/ unplugged with power turned on. Turn the camcorder’s power off and on again, then operate it.
How to clean the LCD monitor, viewfinder and lens of my JVC GR-DV700 Camcorder?
Wipe them gently with soft cloth. Wiping strongly can cause damage.
What to do if my JVC Camcorder is not recording?
If your JVC Camcorder isn't recording, check that the Power Switch is set to 'A' or 'M'. Also, verify the tape’s erase protection tab is set to 'REC'. Ensure the VIDEO/MEMORY Switch is set to 'VIDEO'. If 'TAPE END' appears, replace the cassette. Finally, make sure the cassette holder cover is closed and the VIDEO/MEMORY Switch is set to 'MEMORY'.
What to do if the memory card cannot be removed from my JVC GR-DV700 Camcorder?
Push in the memory card a few more times.
Why does a black bar appear when printing images from my JVC GR-DV700 Camcorder?
When the image is printed from the printer and a black bar appears at the bottom of the screen, this is not a malfunction. By recording with “DIS” activated this can be avoided.
Why is the rear of the LCD monitor hot on my JVC GR-DV700 Camcorder?
The rear of the LCD monitor is hot because the light used to illuminate the LCD monitor causes it to become hot. Close the LCD monitor to turn it off or set the Power Switch to “OFF”, and let the unit cool down.
Why is my JVC GR-DV700 Camcorder remote control not working?
Your JVC Camcorder remote might not be working because the “REMOTE” setting is “OFF”. Set “REMOTE” to “ON”. Also, make sure that the remote control is pointed at the remote sensor. If it still doesn’t work, the remote control batteries may be exhausted, so replace them with fresh ones.
Why is digital zoom not working on my JVC GR-DV700 Camcorder?
If the digital zoom isn't working on your JVC Camcorder, set 'ZOOM' to '40X' or '300X'. Also, ensure the VIDEO/MEMORY Switch is set to 'VIDEO'.
General| Optical Zoom | 10x |
|---|---|
| Image Sensor | CCD |
| Optical Sensor Size | 1/4 inch |
| Video Resolution | 720 x 480 |
| LCD Screen Size | 2.5 inches |
| Image Stabilizer | Electronic |
| Display Type | LCD |
| Viewfinder | Color |
| Microphone Operation Mode | Stereo |
| Battery Type | Lithium-ion |
| Video Recording Format | DV |
| Type | MiniDV |
| Recording Media | MiniDV tape |
| Focus Adjustment | Manual / Auto |
| Microphone | built-in |
| Connector Type | FireWire |
