EasyManuals Logo

JVC GR-DVX400 User Manual

JVC GR-DVX400
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
86 EN
Master Page: Left
GR-DVX707EG_80-103.fm Page 86
31. When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
31. This is not a malfunction. 31. By recording with “DIS”
activated ( pg. 46) this can
be avoided.
32. When the camcorder is
connected via the DV
connector, the camcorder does
not operate.
32. The DV cable was plugged/
unplugged with power
turned on.
32. Turn the camcorder’s power
off and on again, then
operate it.
33. The rear of the LCD monitor is
hot.
33. The light used to illuminate
the LCD monitor causes it to
become hot.
33. Close the LCD monitor to
turn it off or set the Power
Switch to “OFF”, and let the
unit cool down.
34. Images on the LCD monitor
appear dark or whitish.
34. In places subject to low
temperature, images become
dark due to the
characteristics of the LCD
monitor. When this happens,
the displayed colours differ
from those that are actually
recorded. This is not a defect
of the camcorder.
When the LCD monitor’s
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
JVC dealer.
34. Adjust the brightness and
angle of the LCD monitor.
( pg. 13)
35. Coloured bright spots appear
all over the LCD monitor or the
viewfinder.
35. The LCD monitor and the
viewfinder are made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due to
any defect of the unit.
(Effective dots: more than
99.99 %)
35.
36. The indicators and the image
colour on the LCD monitor are
not clear.
36. This may occur when the
surface or the edge of the
LCD monitor is pressed.
36.
37. The cassette will not load
properly.
37. The cassette is in the wrong
position.
The battery’s charge is low.
37. Set it in the right position.
( pg. 16)
Install a fully charged battery.
( pg. 10, 11)
38. The memory card will not load
properly.
38. The memory card is in the
wrong position.
38. Set it in the right position.
( pg. 17)
39. The memory card cannot be
removed from the camcorder.
39.
39. Push in the memory card a
few more times. ( pg. 17)
TROUBLESHOOTING (cont.)
GR-DVX707EG_80-103.fm Page 86 Thursday, January 31, 2002 12:47 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC GR-DVX400 and is the answer not in the manual?

JVC GR-DVX400 Specifications

General IconGeneral
BrandJVC
ModelGR-DVX400
CategoryCamcorder
LanguageEnglish

Related product manuals