EN19
5S
PAUSE
FEATURE:
Quick Review
PURPOSE:
To check the end of the last recording.
OPERATION:
1) Set the Power Switch to “CAMERA” (“AUTO” or
“PRO.”).
2) Press
2
and release quickly during the Record–
Standby mode.
䡲 Tape is rewound for approx. 1 second and played
back automatically, then pauses in Record–Standby
mode for the next shot.
NOTE:
Distortion may occur at the start of playback. This is
normal.
FEATURE:
Retake
PURPOSE:
To re-record certain segments.
OPERATION:
1) Make sure the camcorder is in the Record–Standby
mode.
2) Press and hold either RETAKE to reach the start point
for new recording. Pressing
3
forwards the tape
and pressing
2
reverses it.
3) Press the Recording Start/Stop Button to start
recording.
NOTE:
Noise bars appear and pictures may become
monochrome or darken during Retake. This is normal.
FEATURE:
5Sec. Rec (5-sec. Recording)
(GR-SXM260A/SX210A/
SXM26EA/SX21EA only)
PURPOSE:
To record a scene for 5 seconds, providing quick scene
transitions like those seen in TV programmes.
OPERATION:
䡲 Make sure the recording mode is set to “SP”.
1) During Record–Standby, press 5SEC. REC. “ 5S”
appears and 5Sec. Rec is reserved.
2) Press the Recording Start/Stop Button. Recording
starts, and after 5-second recording is finished, the
camcorder reenters the Record–Standby mode
automatically.
䡲 To cancel the 5Sec. Rec function, press 5SEC. REC
again so that “ 5S” disappears.
NOTE:
Fade/Wipe (
墌
pg. 22) cannot be activated by
pressing 5SEC. REC.
RETAKE
(
2
/
3
)
Button
5 SEC. REC Button
(GR-SXM260A/SX210A/
SXM26EA/SX21EA only)
Display
5 Sec. Rec mode indicator
(GR-SXM260A/SX210A/SXM26EA/SX21EA only)
To Next Page
Loading...
