–14–
MasterPage: Body
Disconnecting the USB cable
Before loading or unloading recording mediums
or turning off the PC, first disconnect the USB
cable and turn off the camera.
1 Confirm that the ACCESS lamp on the
camera does not light or blink.
● If the ACCESS lamp lights or blinks, wait until it is
turned off before proceeding.
2 Double-click the [Safely Remove Hardware]
or [Unplug or Eject Hardware] icon in the
status bar.
The [Safely Remove Hardware] or [Unplug or
Eject Hardware] dialog box appears.
Windows
®
XP: If not, wait a while then go to
step 5.
3 Select [USB Mass Storage Device] or [USB
Disk], and then click [Stop].
4 Click [OK].
Windows
®
2000: If a message indicating that the
device can be safely removed appears, click [OK]
and then click [Close].
5 Disconnect the USB cable.
6 Set the camera’s power switch to off.
The camera turns off.
* The model name depends on the connected
camera.
M6_InstallGuide_Pal_001A_.book Page 14 Wednesday, February 1, 2006 3:54 PM
To Next Page
Loading...
