12
HOW TO USE
1. Connect the transmitter and AV equipment. (Refer to page 6)
2. Connect the AC adaptor to the transmitter, then plug the AC adaptor into an
AC outlet. (Refer to page 7)
3. Turn on the power on the transmitter and the connected AV equipment.
4. Turn on the headphones
’ power. To avoid excessive volume, first set the
headphones’ volume to a low level.
Transmitter power
When an audio signal is input, the transmitter
’s power is turned on automatically, and the
indicator lights in green. Also, when no audio signal is input for about a minute, the
indicator goes out automatically and the power turns off. (Automatic Power On/Off function)
In some situations, the power may not be turned on automatically by the input sound
(e.g. a song with a quiet opening or gradual fade-in). This is not a malfunction.
Before using the headphones for the first time, charge the rechargeable Ni-Cd battery.
13
Tips for better use
For improved sound quality, set the volume level of the connected equipment as high as
possible without causing distortion, while setting the volume level of the headphones to a
slightly lower level.
Within approx.
7 m/23 ft
To set optimum signal reception, adjustments
should be done within a range of approx. 7 m/23 ft
between the transmitter and the headphones.
5. Adjust the volume control of the connected AV equipment and the head-
phones, and set them to the desired listening level.
6. Push the AUTO TUNING switch control to get the best reception in the
headphones.
When the button is pressed, frequency tuning starts automatically and it stops
when a signal is detected.
Note :
Signals not originating from the transmitter or unexpected signals can also cause
the frequency tuning to stop. If this happens, press the button again to resume
tuning.
In cases of interference or too much noise, turn the TUNING control on the
transmitter to another position, then repeat step 6.
HOW TO USE
After use
Keep the headphones
’ power off.
Notes:
1. When using the headphones, don
’t raise the volume excessively. Continuous
listening for a long time at high volumes may damage your hearing.
2. For safety reasons, do not use the headphones while riding a bicycle or driving a
motorcycle, car, etc.
To Next Page
Loading...
Need help?
General
