JVC HR-J635EA - Tune the TV to Your Video Recorder

4 EN
INSTALLING YOUR NEW RECORDER (cont.)
Tune The TV
To Your Video
Recorder
TURN ON THE RECORDER
1
Press OPERATE.
SELECT OUTPUT MODE
2
Set the TEST switch on the back of the recorder to ON.
SET TV CHANNEL
3
Set your TV to the video channel (UHF channel 37).
Two white bars appear on screen vertically.
● Tune the TV until the bars are as clear as they can be.
● Your TV should be set to the channel designated for
use with a video recorder, or to a spare channel if
there is not a specified video channel on your TV.
RESET OUTPUT MODE
4
Return the TEST switch to OFF.
NOTES:
● If CH37 is occupied by a local station, adjust the RF output
channel adjustment screw to use another channel between
CH33 and CH41 instead.
● If some interference noise is continually seen on the screen,
consult your JVC dealer.
The video recorder sends picture and sound signals via the RF
connecting cable to your TV on UHF channel 37.
6
q
Back of VCR
RF OUT
41
TEST
OFF – ON
OUT
OPERATE