21
B.E.S.T.
Picture System
The B.E.S.T. (Biconditional Equalised Signal Tracking) system
checks the condition of the tape in use during recording and
playback, and compensates to provide the highest-possible
recording and playback pictures. The default setting for both
recording and playback is “ON” .
Recording
LOAD A CASSETTE
1
Insert a cassette with the record safety tab intact.
● The recorder power comes on automatically.
ACCESS MODE SELECT
SCREEN
2
Press M O D E. The On-
Screen/B.E.S.T. screen
appears.
CON FIRM B.E.S.T. STATUS
3
The default setting is “ ON”. If this is the case, go to step
4. If not, press PU SH JO G
fi
to place the pointer next to
“ B.E.S.T.” , then press PUSH JO G to set to “ ON”.
CLOSE MO DE SELECT
SCREEN
4
Press M O D E.
START RECORDING
5
Press and hold RECO RD and PLAY on the remote, or
RECORD on the recorder.
● The recorder spends approximately 7 seconds
assessing the condition of the tape, then begins
recording.
● When the "BEST" indicator begins blinking, that
means adjustment is complete.
12
45
3
6
8
0
7
9
2
1
3
6
q
M O DE
RECO RD
ON SCREEN : ON
B.E.S.T. : ON
[ 5
∞
]: SELECT
[ ]: ON/OFF
[MODE] : EXIT
%
Display Panel Indication
As the tape check progresses, the “– –” marks on the display
panel increase upward. Once the "BEST" indicator starts
blinking, the check is complete.
5
PUSH JO G
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
