11
Listening to the Radio
To select the band (FM/AM)
To tune in to a station
While FM or AM is selected...
When a station (frequency) with sufficient signal strength is
tuned in, the frequency search stops.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually,
press either button.
If the received FM station is hard to listen
To restore the stereo effect,
press the button again (the
MONO indicator disappears).
To preset stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset, then enter into
the presetting mode.
2
Select a preset number for the station you store.
3
Store the station.
To tune in to a preset station
1
Select the band (FM or AM).
2
Select a preset number for the station you store.
• You can also use ¢
/4
on the remote control or the
PRESET +/– control on the main unit.
To save the power consumption while on
standby—Eco mode
While on standby...
The display illumination (including the display
demonstration) disappears.
The MONO indicator
lights on the display.
Reception will improve
though stereo effect is
lost—monaural
reception mode.
Main Unit
ONLY
ECO
Canceled
INFO
FM
AM
1
sec.
Increases the frequency.
Decreases the frequency.
Remote
ONLY
(While holding...)
Examples:
To select preset number 5,
press 5.
To select preset number
10, press10.
To select preset number
15, press h
10, 1, then 5.
To select preset number
30, press h
10, 3, then 0.
Remote
ONLY
(While holding...)
(While holding...)
FM
AM
HX-D7[J]_f.book Page 11 Monday, February 13, 2006 3:31 PM
To Next Page
Loading...
Need help?
General
