JVC HX-GD8 - Disc Playback Procedures; Disc Playback Overview and On-Screen Icons; Inserting Discs and Selecting Playback Source; Navigating Titles, Groups, and Tracks

1-16 (No.MB188)
3.1.14 Removing the switch board
(See Fig.27)
• Prior to performing the following procedures, remove the metal
cover and front panel assembly.
(1) From the inside of the front panel assembly, remove the
three screws Z attaching the switch board.
(2) Take out the switch board and remove the soldered section
w on the switch board to remove the parallel wire.
Reference:
When attaching the switch board, align the projections x in the
holes of the switch board before attaching the screws Z.
3.1.15 Removing the standby LED board
(See Fig.27)
• Prior to performing the following procedures, remove the metal
cover and front panel assembly.
(1) From the inside of the front panel assembly, remove the
two screws AA attaching the standby LED board.
(2) Take out the standby LED board and remove the soldered
section y on the standby LED board to remove the parallel
wire.
Reference:
When attaching the standby LED board, align the projections
z in the holes of the standby LED board before attaching the
screws AA.
Fig.27
Z
Z
Z
AA
AA
Front panel assembly
z
z
x
x
w
x
y
Parallel wires
Standby LED board
Switch board