JVC HX-GD8 - Advanced Disc Navigation; Direct Selection of Playback Items; Utilizing Disc Menus for Playback Control; Managing PBC and Canceling Playback Control

(No.MB188)1-17
3.1.16 Removing the encoder board
(See Figs.26 to 29)
• Prior to performing the following procedures, remove the metal
cover and front panel assembly.
(1) From the outside of the front panel assembly, pull out the
knobs toward this side. (See Fig.28.)
(2) From the inside of the front panel assembly, disconnect the
card wire from the connector CN902
on the FL board. (See
Fig.26.)
(3) Remove the four screws Y, three screws Z and two screws
AA attaching the each board. (See Figs.26 and 27.)
(4) Take out the FL board with the switch and standby LED
boards.
Reference:
It is not necessary to remove the parallel wires.
(5) Remove the eight screws AB attaching the encoder board.
(See Fig.29.)
Reference:
When attaching the encoder board, align the projections aa of
the front panel assembly in the holes of the encoder board be-
fore attaching the screws AB. (See Fig.29.)
Fig.28
Fig.29
Front panel assembly
Volume knob
Sound mode knob
Preset knob
AB
AB
AB
AB
aa
aa
Encoder boardFront panel assembly