JVC HX-GD8 - Tape Playback Operations; Inserting and Playing Cassette Tapes; Tape Direction and Reverse Mode Settings; Music Scan for Locating Recordings

1-18 (No.MB188)
3.1.17 Removing the microphone board
(See Fig.30)
• Prior to performing the following procedure, remove the metal
cover and front panel assembly.
From the inside of the front panel assembly, remove the seven
screws AC and screw AC' attaching the microphone board.
Reference:
• When attaching the microphone board, align the projections
ab of the front panel assembly in the holes of the micro-
phone board before attaching the screws AC and AC'.
• When attaching the screw AC', attach the wire holder with it.
Fig.30
3.1.18 Removing the headphone board
(See Fig.31)
• Prior to performing the following procedures, remove the metal
cover and front panel assembly.
(1) From the inside of the front panel assembly, remove the
screw AD attaching the headphone board.
(2) Remove the wire holder fixing the wire and take out the
headphone board.
Reference:
After attaching the headphone board, fix the wire with the wire
holder.
3.1.19 Removing the cassette mechanism assembly
(See Fig.31)
• Prior to performing the following procedure, remove the metal
cover and front panel assembly.
(1) From the inside of the front panel assembly, remove the
two screws AE and two screws AF attaching the cassette
mechanism assembly.
Reference:
When attaching the cassette mechanism assembly, align the
projections (ac, ad) in the holes of the cassette mechanism as-
sembly.
Fig.31
Front panel assembly
ab
AC AC AC
AC'AC
Wire
Wire holde
r
ab
Microphone board
ab
Front panel assembly
AE
AF
AF
AD
AE
Wire
ad
Wire holder
Cassette mechanism assembly
Headphone board
ac