JVC In-Dash DVD Player KD-LX50R User Manual

71
ENGLISH
3
Start searching an ensemble.
When an ensemble is received, searching stops.
4
Select an service you want to listen to.
1 Press MODE BAND.
“MODE” appears on the lower part of the display.
2 Press
¢ or 4 to select a service you want,
while “MODE” is still on the display.
To search ensembles
of higher frequencies.
To stop searching before an ensemble is received, press the same button you have pressed
for searching.
To change the display information while tuning into an
ensemble
Normally service name is shown on the upper part of the display.
If you want to check the ensemble name or its frequency, press DISP.
Each time you press the button, the following information appears for a while on the upper
part of the display.
To tune in a particular ensemble without searching:
1 Press SOURCE (ATT) to select DAB tuner as the source.
2 Press MODE BAND repeatedly to select the DAB band (DAB1, DAB2, or DAB3).
3 Press and hold
¢ or 4 for more than 1 second.
4 Press
¢ or 4 repeatedly until the ensemble you want is reached.
• If you hold down the button, the frequency keeps changing until you release the button.
Ensemble nameService name
Channel number Frequency
2
1
To search ensembles
of lower frequencies.
EN70-75.KD-LX50R[E]/f 00.3.22, 10:39 AM71

JVC In-Dash DVD Player KD-LX50R Specifications

General

Brand	JVC
Model	In-Dash DVD Player KD-LX50R
Category	Car Receiver
Language	English