JVC KD-AVX40 - Page 69

Remedies/Causes
• Readout time varies depending on the USB device.
• Do not use too many hierarchy, folders and empty
folders.*
* Folder that is physically empty or folder that contains
data but does not contain valid MP3IWMAIW AV track.
• Turn off the power then on again.
• Do not pull out or connect the USB device repeatedly
while /lNow Reading .. :' is displayed on the monitor.
For available characters, 1& page 64.
The tracks have not been properly copied into the USB
device. Copy tracks again into the USB device, and try
again.
• Search from the Bluetooth device again.
• Reset the unit. When /lOpen ... /I appears on the monitor,
search from the Bluetooth device again.
• Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on
its manuals, try /10000/1 or /11234./1
• Reduce the distance between the unit and the Bluetooth
cellular phone.
• Move the car to place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio player.
• Disconnect the device connected for Bluetooth phone.
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the device
again.
Check whether the connected a udio player supports AVRCP
(AudioNideo Remote Control Profile).
You may have tried to copy the same entries (as stored) to
the unit. Touch BAND to exit.
Connect this unit and the Bluetooth audio player correctly.
The connected cellular phone does not have the voice
recognition system.
69
REFERENCES