3
WARNINGS:
To prevent accidents and damage
• DO NOT install any unit in locations where;
– it may obstruct the steering wheel and
gearshift lever operations.
– it may obstruct the operation of safety
devices such as air bags.
– it may obstruct visibility.
• DO NOT operate the unit while driving.
• If you need to operate the unit while
driving, be sure to look ahead carefully.
• The driver must not watch the monitor
while driving.
If the parking brake is not engaged,
“DRIVER MUST NOT WATCH THE MONITOR
WHILE DRIVING.” appears on the monitor,
and no playback picture will be shown.
– This warning appears only when the
parking brake wire is connected to the
parking brake system built in the car
(refer to the Installation/Connection
Manual).
How to reset your unit
• Your preset adjustments will also be erased (except
the registered Bluetooth device, see page 29).
How to forcibly eject a disc
“PLEASE” and “EJECT” appear alternately on the
display.
• Be careful not to drop the disc when it ejects.
• If this does not work, reset your unit.
How to use functions mode
If you press M MODE, the unit goes into functions
mode, then the number buttons (except “1”) and
5/∞ buttons work as different function buttons.
[Within 5 seconds...]
EN02-07_DV7306_005A_f.indd 3EN02-07_DV7306_005A_f.indd 3 2/9/07 1:48:44 PM2/9/07 1:48:44 PM
To Next Page
Loading...
Need help?
General
