(No.MA665<Rev.001>)17/33
4.2 Production Test Mode
In during power off, pressing and holding [1] key and [3] key, then power on the +B power supply.
4.2.1 Test Mode Defaults
During Production Test Mode, the following settings defer from the Normal Mode.
The settings will change immediately after mode activation.
Difference in action Setting value
Period to prohibit TEL/LINE MUTE function (Normal Mode: 10 secs) 1 second
Mecha Initialize Action Prohibited
Writing-in to E2PROM when DC error is detected Prohibited
"DEMO" item in Setup Menu OFF
Power supply during ACC OFF (Back Up On) MUTE terminal turns OFF after 2 seconds
"BEEP" item in Setup Menu ON
Volume range 0 to 33
Source change interval timer 0 seconds
When 0-bit mute is detected Mute off
Various setting item Setting value
Default Volume 33
"BASS BOOST" OFF
"LOUDNESS" OFF
"TEL MUTING" ON
Initial Source CD
Language English
EQ FLAT
Fader / Balance Center
Digital Track Expander(K2) / Sound Reconstruction Set OFF
1.Space Enhancement OFF
2. Volume Link EQ OFF
3. Sound Response OFF
4. Sound Lift OFF
"VOL ADJUST" / "VOLUME OFFSET" 0
DEMO Mode Setting OFF
Tweeter : Speaker Size None
5. SETUP > Audio > Speaker / X'over > Front/Rear > X'over > HPF FREQ Through
6. SETUP > Audio > Speaker / X'over > Subwoofer > X'over > LPF FREQ Through
7. SETUP > Audio > Speaker / X'over > Front/Rear/ Subwoofer > X'over > SLOPE -12dB/ OCT
8.SETUP > Audio > Speaker / X'over > Front/Rear/Subwoofer > X'over > GAIN 0dB
9.SETUP > Audio > Speaker / X'over > Subwoofer > X'over > PHASE Normal
Sub-woofer/ Rear (For L/O switchable models) Rear
To Next Page
Loading...
Need help?
General
