JVC KD-S71R - Sound Adjustments; Adjusting Sound Characteristics; Selecting Preset Sound Modes

20
ENGLISH
Ex.: When you select “BEAT”
SCM
BEAT SOFT POPSCM OFF
SCM
SOUND ADJUSTMENTS
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1 Select the item you want to adjust.
Each time you press the
button, the adjustable items
change as follows:
Indication To do: Range
BAS Adjust the bass. –06 (min.)
|
+06 (max.)
TRE Adjust the treble. –06 (min.)
|
+06 (max.)
FAD* Adjust the front R06 (Rear only)
and rear speaker |
balance. F06 (Front only)
BAL Adjust the left L06 (Left only)
and right speaker |
balance. R06 (Right only)
LOUD Boost low and
high frequencies LOUD ON
to produce a well- |
balanced sound LOUD OFF
at low volume
level.
VOL Adjust the volume. 00 (min.)
|
50 (max.)
* If you are using a two-speaker system, set the fader
level to “00.”
2 Adjust the setting.
Note:
Normally, the + and – buttons work as the volume
control buttons. So you do not have to select “VOL”
to adjust the volume level.
Selecting preset sound modes
You can select a preset sound adjustment
suitable to the music genre.
Select the sound mode you want.
Each time you press the
button, the sound mode
changes as follows:
To decrease the level or turn
off the loudness
To increase the level or turn
on the loudness
VOL
(volume)
BAS
(bass)
TRE
(treble)
FAD
(fader)
BAL
(balance)
LOUD
(loudness)
Ex.: When you adjust “TRE” (treble)
SEL
SCM
EN20-21_KD-S743R[E_EX]f.p65 11/18/02, 6:37 PM20