22
ENGLISH
3
Adjust the bass or treble, or turn the
loudness function ON/OFF.
• See page 20 for details.
4
Repeat steps 2 and 3 to adjust the
other items.
5
Press and hold SCM until the sound
mode you have selected in step 1
flashes on the display.
6
Repeat the same procedure to store
other sound modes.
To reset to the factory settings
Repeat the same procedure and reassign the
preset values listed in the table on page 21.
Storing your own sound
adjustments
You can adjust the sound modes (BEAT, SOFT,
POP) to your preference and store your own
adjustments in memory.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Call up the sound mode you want to
adjust.
• See “Using the sound control memory
(SCM)” on page 21 for details.
2
Select “BAS (bass)”, “TRE (treble)” or
“LOUD (loudness)”.
SEL
SCM
Ex.: When you select “SOFT”
SCM
Your adjustment made for the selected
sound mode is stored in memory.
EN20-22KD-S871R[E]f.pm5 14/12/01, 7:29 PM22
To Next Page
Loading...
Need help?
General
