IMPORTANT
Notice the following information will help you solve your problems.
Keep this IMPORTANT sheet together with the INSTRUCTIONS book.
• After installing the unit
= Follow the procedure Å described below.
• If the unit does not operate
= Follow the procedure Å described below.
• If a CD is not ejected from the loading slot
= Follow the procedure ı described below. (If the procedure ı does not work, try
the procedure Å.)
• If a CD is not recognized (“NO DISC” or “EJECT ERR” appears
on the display) even though there is a CD in the loading slot
= Follow the procedure ı described below. (If the procedure ı does not work, try
the procedure Å.)
Å To reset the microcomputer
Press the reset button on the front panel using a ball-point pen or a similar tool.
This will reset the built-in microcomputer.
NOTE: Your preset adjustments — such as preset channels or sound
adjustments — will also be erased.
ı To eject a CD by force
While pressing , press and hold for more than 2 seconds. (Be careful not
to drop the CD when ejecting.)
LVT0732-001A
Reset button
button
button
ImportantSheet-77/55J_f 01.1.9, 10:44 AM1
To Next Page
Loading...
Need help?
General
