JVC KD-T902BT

28
ENGLISH
DISPLAY SETTINGS
[COLOR] (for KD-T901BT: Symbolic button only)
[PRESET] Selects an illumination color for the symbolic button. (See the illustration
on page 27.)
• [COLOR01] to [COLOR49]
• [USER]: The color you have created for [DAYCOLOR] or [NIGHTCOLOR]
is shown.
• [COLORFLOW01] to [COLORFLOW03]: Color changes at different
speeds.
• Preset color: [CRYSTAL]/[FLOWER]/[FOREST]/[GRADATION]/[OCEAN]/
[RELAX]/[SUNSET]
[DAYCOLOR] Stores your own day and night illumination colors for the symbolic button.
1 [RED]/[GREEN]/[BLUE]: Select a primary color.
2 [00] to [31]: Select the level.
Repeat steps 1 and 2 for all the primary colors.
• Your setting is stored to [USER] in [PRESET].
• [NIGHTCOLOR] or [DAYCOLOR] is changed by turning on or off your
car’s headlights.
[NIGHTCOLOR]
[MENUCOLOR]
[ON]: The illumination color of the symbolic button changes to white color
when settings are performed on menu and list search, except in color setting
mode. ; [OFF]: Cancels.
*1 The illumination control wire connection is required. (Page 37)
*2 Some characters or symbols will not be shown correctly (or will be blank).
*3 Functionality depends on the type of phone used.
*4 If one of these color patterns is selected, the [ZONE1] and [ZONE2] illumination colors will
change to the default colors.
[FORMAT]*3 Below information is shown on the supplementary display when Bluetooth
device is connected. (Page 30)
[BATT/SIGNAL]: Shows the strength of the battery and signal. ;
[DATE]: Shows the date.
[COLOR] (for KD-T902BT)
[PRESET] Selects illumination colors for the buttons on different zones separately.
1 Select a zone ([ZONE1], [ZONE2], [ALLZONE]). (See the illustration on
page 27.)
2 Select a color for the selected zone.
• [COLOR01] to [COLOR49]
• [USER]: The color you have created for [DAYCOLOR] or
[NIGHTCOLOR] is shown.
• [COLORFLOW01] to [COLORFLOW03]: Color changes at different
speeds.
• [CRYSTAL]/[FLOWER]/[FOREST]/[GRADATION]/[OCEAN]/[RELAX]/
[SUNSET]: The selected color pattern is shown.*4 (Selectable only
when [ALLZONE] is selected in step 1.)
[DAYCOLOR] Stores your own day and night illumination colors for different zones.
1 Select a zone ([ZONE1], [ZONE2]). (See the illustration on page 27.)
2 [RED]/[GREEN]/[BLUE]: Select a primary color.
3 [00] to [31]: Select the level.
Repeat steps 2 and 3 for all the primary colors.
• Your setting is stored to [USER] in [PRESET].
• [NIGHTCOLOR] or [DAYCOLOR] is changed by turning on or off your
car’s headlights.
[NIGHTCOLOR]
[COLOR GUIDE]
[ON]: The illumination color of [ZONE1] and [ZONE2] change to white
color when settings are performed on menu and list search, except in color
setting mode. ; [OFF]: Cancels.