EasyManuals Logo

JVC KS-AX204 User Manual

JVC KS-AX204
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
LVT2505-001A_KS-AX204.indd 2LVT2505-001A_KS-AX204.indd 2 9/26/13 1:01 PM9/26/13 1:01 PM
English
TERMINAL CONNECTION
Use ring terminals (not provided) for secure connection.
POWER SUPPLY CONNECTION
The proper lead wire connected to each POWER terminal is as
follows.
+ B and GND: AWG 8 to AWG 4
(The cross section is about 8 mm
2
to 21 mm
2
.)
REM: AWG 18 to AWG 8
(The cross section is about 0.8 mm
2
to 8 mm
2
.)
¡ Connect to metallic body or chassis.
-a When you use JVC car receiver with REMOTE OUTPUT, connect
to REMOTE OUTPUT.
-b When you use a unit without REMOTE OUTPUT, connect to the
accessory circuit of the car which is activated by the ignition
switch. In this case, noise may occur when the car receiver is
turned on or off. To avoid this noise, do not turn on or off the
car receiver itself. You can turn on or off the car receiver along
with the on/off operation of the ignition switch.
£ After all connections have been made, connect to the battery
12 V.
Be sure to place the fuse near the battery as shown.
4 Car battery
5 Ignition switch
6 JVC car receiver, etc.
* Not supplied
TERMINAL CONNECTION POWER SUPPLY CONNECTION
English
AUDIO INPUT CONNECTION
When your receiver is equipped with line output.
1 JVC car receiver, etc.
2 Line out (Front)
3 Line out (Rear)/ Subwoofer
*1 Not supplied
When your receiver is NOT equipped with line output.
White “FRONT LEFT (+)” Black “RECEIVER GND”
Green “REAR LEFT (+)” Gray “FRONT RIGHT (+)”
Black “RECEIVER GND”
Purple “REAR RIGHT (+)”
4 JVC car receiver, etc.
*2 Example: connecting to the ground
*3 Rear ground terminal
SPEAKER CONNECTIONS
The proper lead connected to each SPEAKER OUTPUT terminal is AWG
18 to AWG 12. (The cross section is about 0.8 mm
2
to 3.3 mm
2
.)
4-speaker system—Normal Mode
Use the speakers with an impedance of 2 Ω to 8 Ω.
1 Right Front 2 Left Front
3 Right Rear 4 Left Rear
2-speaker system plus subwoofer—Bridge Mode
Use the speakers with an impedance of 2 Ω to 8 Ω.
Use the subwoofer with an impedance of 4 Ω to 8 Ω.
5 Right Front 6 Left Front
7 Subwoofer
AUDIO INPUT CONNECTION SPEAKER CONNECTIONS
2
3
2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC KS-AX204 and is the answer not in the manual?

JVC KS-AX204 Specifications

General IconGeneral
BrandJVC
ModelKS-AX204
CategoryCar Stereo System
LanguageEnglish

Related product manuals