JVC KW-ADV793 - Changing HD Radio Reception Mode; Tuning in to Stations with Sufficient Signal Strength

25
ENGLISH
Changing HD Radio reception
mode
While receiving an HD Radio broadcast, the unit tunes
to digital or analog audio automatically due to the
receiving condition.
1
2
Analog Tuning to analog audio only.
Digital Tuning to digital audio only.
Auto Switch between digital and analog
audio automatically.
• If no sound can be heard from the selected setting,
change the setting to <Analog> or <Digital>.
• The setting automatically changes to <Auto> if you
tuned in to or change to another station, or if you
turned off the power.
• This setting cannot take effect for the conventional
FM/AM stations.
• If the radio station forces the reception mode to
digital, the DIGITAL indicator flashes.
• To improve FM reception, see “When an FM stereo
broadcast is hard to receive...,”
11.
• To preset stations automatically, see “Automatic
presetting — SSM (Storing-station Sequential
Memory) (for FM only),” 12.
AnalogDigital
Auto
Off
Local
On
DX
Start
Mode
Mono
DX/Local
SSM
Blend Hold
Mode
Tuning in to stations with
sufficient signal strength
This function works only for FM bands. Once you have
activated this function (selected <Local>), it always
works when searching for FM stations.
1
2
Only stations with sufficient signal strength will be
detected.
• The DX indicator goes off, then the LO indicator lights
up.
Mode
Digital
Off
Local
On
DX
Start
Mode
Mono
DX/Local
SSM
Blend Hold
Analog
Auto
EN11-29_AV_AVX838[J].indd 25EN11-29_AV_AVX838[J].indd 25 10.5.12 4:43:40 PM10.5.12 4:43:40 PM