Connection/Installation
50
NOTE
• Swap the clips if necessary.
Ñ Removing the trim plate
1) Use the extraction key (accessory 5 to lever
out the four tabs (two on the left part, two on
the right part).
2) Pull the trim plate forward.
Ñ Removing the unit
1) Remove the trim plate by referring to step 1
in “Removing the trim plate”.
2) Insert the extraction key (accessory 2)
deeply into the slot as shown. (The protrusion
at the tip of the extraction key must face
toward the unit.)
2
3) With the inserted extraction key secured,
insert the other extraction key into the slot.
4) Pull out the unit halfway.
NOTE
• Be careful to avoid injury from the catch
pins on the extraction key.
5) Pull the unit all the way out with your hands,
being careful not to drop it.
5
!B5A-2246-20_JVC_EnFr_2nd.indb 50 2019/06/14 14:05
To Next Page
Loading...
