JVC KW-V130BT - BLUETOOTH - Device Management; Connecting;disconnecting a registered Bluetooth device; Deleting a registered Bluetooth device

40
BLUETOOTH
BLUETOOTH
R Connecting/disconnecting a registered
Bluetooth device
Two devices can be connected simultaneously.
1 Display the <Bluetooth Setup> screen.
(Page39)
2
3 Select the device you want to connect (1),
then press [Connection] (2).
4 Select [ON] (to connect) or [OFF] (to
disconnect) for the target (1), then display
the <Paired Device List> screen (2).
:
Mobile phone
:
Audio device
:
Device for using Apps
• The status is shown as follows:
– “Connecting”: Connection is in progress.
– “Connected”: A connection has been
established.
– “Connect Ready”: A connection can be
established.
– “Disconnecting”: Disconnection is in
progress.
– “Disconnected”: No connection is
established.
5 Connect the selected device.
• When a Bluetooth mobile phone is connected,
the signal strength and battery level are displayed
when the information is acquired from the device.
R Deleting a registered Bluetooth device
1 Display the <Bluetooth Setup> screen.
(Page39)
2
3 Select a device to delete (1), then press
[Remove] (2).
A confirmation message appears. Press [Yes].
2017KW-VEntryK.indb40 2016/06/0221:22