JVC KW-V320BT - Using the steering remote controller; Registering;changing the functions

ENGLISH 57
REMOTE CONTROLLER
REMOTE CONTROLLER
Using the steering remote
controller
You can assign functions to the keys of the remote
controller on the steering wheel.
• This function is available only when your vehicle
is equipped with the electrical steering remote
controller.
• You can only register/change the functions while
you are parked.
• If your steering remote controller is not
compatible, learning may not be completed and
an error message may appear.
❏ Registering/changing the functions
1 Display the <System> setting screen.
On the Home screen:
2 Display the <Steering Remote Control
Setting> screen.
• Press [ ] repeatedly to change the page on
the <System> menu screen.
3 Press and hold a steering remote controller
button to register/change.
4 Select a function to assign.
• You can change the page to display more
items by pressing [
]/[ ].
5 Repeat steps 3 and 4 as necessary.
6 Finish the procedure.
• The unit can register/change all of the buttons’
functions at the same time. To do this, press each
button in turn and after pressing all of them,
press [Done] on the <Steering Remote Control
Setting> screen. However, new functions cannot
be learned after this operation.
• When changing the functions already learned,
touch the button you want to change in step 3
and then touch to select the new function from
the function list.
• Confirm the contents of the settable functions in
the function list. You cannot edit the function list.
❏ Initializing the settings
1 Display the <System> setting screen. (See
the far left column.)
• Press [ ] repeatedly to change the page on
the <System> menu screen.
2
3
• To cancel the initialization, press [No].
2016KW-VEntryM.indb 572016KW-VEntryM.indb57 2015/09/15 15:522015/09/1515:52