JVC KW-V420BT - Page 61

ENGLISH 61
CONNECTION/INSTALLATIONCONNECTION/INSTALLATION
❏ Installation procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the
·
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7 Reconnect the · battery.
8 Press the reset button. (Page3)
9 Configure <Initial Settings>. (Page4)
Installing the unit
❏ Installing the unit (only for KW-V420BT
Region 4/KW-V320BT Region 4/
KW-V220BT Region 4)
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
❏ Installing the unit using the mounting
bracket removed from the car
Car Bracket
5 or 6
5 or 6
• Select the appropriate type of screw for the
mounting bracket: flat head (5) or round head
(6).
❏ Installing the trim plate (only for
KW-V420BT Region 4/KW-V320BT
Region 4/KW-V220BT Region 4)
1 Attach the trim plate (2).
2
2016KW-VEntryK.indb612016KW-VEntryK.indb61 2015/09/2510:482015/09/2510:48