JVC KW-V820BTM - Page 61

REMOTE CONT
STEERING WHEEL
REMOTE INPUT
P.CONT
ILLUMI
PRK SW
REVERSE
(ACC)
(BATT)
(GND)
ANT CONT
1
VIDEO OUT
REAR VIEW CAMERA
ENGLISH 61
CONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals
15 A fuse
Ignition key switch
Fuse box
Battery
Connect to the vehicle’s reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle’s parking brake
detection switch harness.
• For best safety, be sure to connect the
parking sensor.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or to
the power terminal for the booster amplifier of the film-
type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its
power control terminal.
To use the steering wheel remote control feature, an
exclusive remote adapter (not supplied) matching your
car is required.
To car light control switch
To car chassis
Purple with white stripe (Reverse
sensor wire)
Light green (Parking sensor wire)
To front speaker (left)
To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power
control wire)
Light blue with yellow stripe
(Steering remote control wire)
Orange with white stripe (Dimmer
control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
If no connections are made, do not let
the cable come out from the tab.
Connect the antenna cord
to the antenna terminal.
White
White with black stripe
Gray
Gray with black stripe
To front speaker (right)
Green
Green with black stripe
To rear speaker (left)
Purple
Purple with black stripe
Connect the USB extension cable (4). (Page62)
Connect GPS antenna (5). (Page65)
Connect a navigation box. (Page64)*
Connect to the vehicle’s steering remote harness using the Steering remote cable
(7). (Page64)
• Contact your JVC dealer for details.
Page64Page65
Pages62 – 64
Page64
Page64
* Only for KW-V820BTM.