JVC KW-V850BT - Controlling Audio

Controlling Audio
73English
Controlling Audio
You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [Audio].
See the following section for each
setting.
• Set up speaker / X’over (P.74)
• Controlling equalizer / subwoofer level
(P.76)
• Set listening position / DTA (P.80)
• Controlling general audio (Fader /
Balance) (P.76)
• Set volume offset (P.77)
• Performing zone control (P.78)
• Set sound effect (P.79)
• Memory/recall the audio settings
(P.82)
3-way speaker system setup
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [ ].
 HOME screen appears.
3
Touch [ ].
 Source selection screen appears.
4
Touch [AV Off].
5
Press the button 1 followed by the
button 2 for 1 second at the same time.
KW-V850BT/ KW-V85BT/
KW-M750BT/ KW-M75BT
12
KW-M650BT
1
2
 Speaker system select screen appears.
6
Select the crossover network mode.
 A confirmation screen appears.
7
Touch [Ye s ].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.