E71
Specifications
Imaging device: 1/2 inch IT CCD × 3
Scanning type: Progressive
Available pixels: 1.45 million pixels (1392 (H) × 1040 (V))
Effective no. of pixels: 1360 × 1024
Colour separation: Dichroic prism
Aspect ratio: Approx. 4:3
V.SCAN speed: 1/30 s to 1/5906.8 s
Detail compensation: both H and V dual-edged
Lens mount: C mount
Analog output: R/G/B signal: 0.7V (p-p), 75 Ω
Output signals: a 1360 × 1024 pixels, 7.5 frames/sec.
(Select from a, b or c) b 640 × 480 pixels, 60 frames/sec.
(refresh rate: 7.5 frames/sec., vertical resolution of 480 lines)
c 640 × 280 pixels, 60 frames/sec.
(refresh rate: 30 frames/sec., vertical resolution of 240 lines)
Synchronization: internal
Sync signal output:
Hs, Vs 3.3V (p-p) negative polarity or SYNC ON GREEN 0.3V (p-p)
SCSI output: SCSI-2, 50-pin half-pitch SCSI connector
Output modes: Can switch between target and initiator
Built-in framestore capacity: 5 incompressed images at SXGA resolution or 4 when output
signal is a
Operating temperature range:
0°C to 40°C (with humidity of less than 80%RH)
Input voltage: DC 12V
Power consumption: Max. 15W
Mass: Approx. 850g
Item When using KY-SCSI When using TWAIN driver
CPU Pentium
®
133 MHz or higher Pentium
®
166 MHz or higher
OS Windows
®
95 (OSR2)/98/NT4.0
Memory 64 MB or more built-in 32 MB or more built-in (64 MB or more recommended)
Hard disk 20 MB or more empty space 100 MB or more empty space
SCSI board Adaptec Inc. AHA-2940AU
Video board Resolution of 800 x 600 or higher, full-color display (Video RAM 4 MB or more recommended)
Connectable PC models: PC/AT compatible machines (DOS/V) complying with
the following conditions.
To Next Page
Loading...
