41
ENGLISH
Etc.AdvancedBasicsGetting started
Supported music formats for Photo Viewer
Sample rate
32, 44.1, and 48 kHz (MPEG-1 Audio Layer-3)
16, 22.05, and 24 kHz (MPEG-2 Audio Layer-3)
8, 11.025, and 12 kHz (MPEG-2.5 Audio Layer-3)
Resolution
16 bit
Channels
monaural, stereo
Bit rate
32, 40, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224, 256, and 320 kbps
Some les may not be able to playback depending on the combination
between the sample rate and the bit rate.
100Hz Clear Motion Drive II
Most conventional LCD panel uses 50 frames per second (50 Hz) to display
an image which needs long holding time (time it takes to display single
frame), causing blurring or ghost images when there is rapid or complex
movement across the screen - a phenomenon common to all LCD panels.
This TV is equipped with JVC’s original “100Hz Clear Motion Drive II”
technology, which displays two frames (the original plus the new
interpolated frame) in the time a 50 Hz set displays a single frame.
Resulting to double the typical rate, 100 frames per second (100 Hz) and
halve the holding time without reducing brightness or contrast. By using this
technology you will be able to reduce blurring or ghost images when there is
rapid or complex movement across the screen.
By using “Auto Demonstration” (P. 34)”, you can display the differences
between conventional LCD (50 Hz) and LCD panel equipped with “100Hz
Clear Motion Drive II”.
Left side of the screen: Moving image of LCD panel equipped with “100Hz
Clear Motion Drive II” (100 frames per second)
Right side of the screen: Moving image of 50 Hz conventional LCD (50
frames per second)
*1
*1 To simulate Moving image of conventional LCD, the TV will display two
same frames at a time.
When the images are 60 frames per second (60 Hz), it will be produced
as 120 frames per second (120 Hz)
To Next Page
Loading...
Need help?
General
