17
* If you use a set top box (satellite or cable box), press “Exit” to
skip this step.
“Thank you! Setup is now complete”
Setup
1 Change settings
4) Set TV attribute
Start Scan Exit
Set TV Attribute
Tuner Mode Air
2 Select an item
4 Start scanning
channels
3 Select “Start Scan”
Tuner Mode Choose Air (antenna) or Cable
Initial setup (Continued)
Cable Users: After your auto tuner setup is complete, you may,
(depending on the type of hookup), have only 1 channel, usually
2, 3 or 4 in the auto tuner memory. This is normal.
LCT2389-001A-A English.indd 17LCT2389-001A-A English.indd 17 3/25/08 3:32:04 PM3/25/08 3:32:04 PM
To Next Page
Loading...
