MX-G500
1-17
Prior to performing the following procedure, remove
the side panel.
Remove the five screws A attaching the side panel
and remove the side panel.
1.
Removing the side panel (See Fig. 1)
Remove the four screws B attaching the side
speaker.
Pull out the side speaker and remove the speaker
cord from the speaker terminal.
1.
2.
Removing the side speaker
(See Fig. 2 and 3)
< Speaker section >
It is exchange in a unit.
Please do not decompose as much as possible.
NOTES : It will be good to use the tool with a flat tip, since a
boss's portion is pasted with adhesives. Please take care not to
damage the cabinet at this time.
Side panel
Side speaker
Front panel
Side speaker
Speaker terminal
Fig.1
A(long wood screw)
A(long screw)
A(short wood screw)
B
Fig.2
Fig.3
Boss and adhesion
Boss and
adhesion
To Next Page
Loading...
Need help?
General
