JVC MX-GA9V - Page 16

1-16 (No.MB011)
3.2.2 Removing the display system control board
(See Fig.28 ~ 30)
(1) Remove the four screws O attaching the stay bracket.
(2) Disconnect the card wires from connector CN316 and
CN880 on the display system control board.
(3) Remove the seven screws P attaching the display system
control board.
(4) If necessary, disconnect the wire from connector CN911
on
the front side of the display system control board and un-
solder FW915.
3.2.3 Removing the CD eject board
(See Fig.30, 31)
(1) Remove the three screws Q attaching the CD eject board.
(2) If necessary, unsolder FW915 on the CD eject board.
Fig.28
Fig.29
Fig.30
Fig.31
O
Display system control board
Stay bracket
P
P
P
P
CN316
CN880
FW915
(Solding)
P
Display system control board
FW915
FW915
CD eject board
CN911
Display system control board
CD eject board
FW915
(Solding)
Q
Q