(No.MB011)1-21
3.3.4 Removing the CD traverse mechanism
(See Fig.11 and 12)
(1) For dismounting only the CD traverse mechanism without
removing the CD loading mechanism assembly, align the
shaft j of the CD loading mechanism assembly to the po-
sition shown Fig.11 while turning the cam R1 and R2 as-
sembly in the arrow direction k .
(2) By raising the CD loading mechanism assembly in the ar-
row direction l , remove the assembly from the lifter unit.
Fig.11
Fig.12
3.3.5 Removing the CD pick unit
(See Fig.13)
(1) Move the cam gear in the arrow direction m . Then, the CD
pickup unit will be moved in the arrow direction n .
(2) According to the above step, shift the CD pickup unit to the
center position.
(3) While pressing the stopper retaining the shaft in the arrow
direction o , pull out the shaft in the arrow direction p .
(4) After dismounting the shaft from the CD pickup unit, re-
move the CD pickup unit.
Fig.13
Cam R1, R2 assembly
k
Arrow
Lifter unit
CD traverse mechanism
l
Arrow
CD Pickup unit
CD loading
mechanism
Cam gear
Shaft
Stopper Stopper
o
p
n
m
Shaft
Shaft
To Next Page
Loading...
