(No.MB011)1-23
3.3.8 Removing the actuator motor and belt
(See Fig.18~21)
(1) Remove the two screws I retaining the gear bracket.
(2) While pressing the pawl t fixing the gear bracket in the ar-
row direction, remove the gear bracket.
(3) From the notch u section on the chassis assembly fixing
the edge of gear bracket, remove and take out the gear
bracket.
(4) Remove the belts respectively from the right and left actu-
ator motor pulleys and pulley gears.
(5) After turning over the chassis assembly, remove the actu-
ator motor while spreading the four pawls v fixing the right
and left actuator motors in the arrow direction.
ATTENTION:
When the chassis assembly is turned over under the condi-
tions wherein the gear bracket and belt have been removed,
then the pulley gear as well as the gear, etc. constituting the
gear unit can possibly be separated to pieces. In such a case,
assemble these parts by referring to the assembly and config-
uration diagram in Fig. 21.
Fig.18
Fig.19
Fig.20
Fig.21
Pulley gear
Belt
Motor pulley
Belt
Pulley gear
Motor pulley
Gear bracket
t
I
I
Pawl
Chassis assembly
u
Gear bracket
v
Actuator motor
v
Pulley gear
Gear B
Cylinder gea
Gross gear U
Gear C
Gross gear L
Select gear
Gear B
Gear C
Pulley gear
Assembly and Configuration Diagram
To Next Page
Loading...
