1-24 (No.MB011)
3.3.9 Removing the cams R1/R2 assembly and cam gear q
(See Fig.22)
(1) Remove the slit washer fixing the cams R1 and R2 assem-
bly.
(2) By removing the two pawls w fixing the cam R1, separate
R2 from R1.
(3) Remove the slit washer fixing the cam gear q .
(4) Pull out the cam gear q from the C.G. base assembly.
3.3.10 Removing the C.G. base assembly
(See Fig.22 and 23)
(1) Remove the three screws J retaining the C.G. base as-
sembly.
CAUTION:
To reassemble the cylinder gear, etc.with the cam unit (cam
gear and cans R1/R2 assembly), gear unit and drive unit, align
the position of the pawl x on the drive unit to that of the notch
on the cam gear q . Then, make sure that the gear unit is en-
gaged by turning the cam gear q .
Fig.22
Fig.23
Slit washer
Pawl
Cam R2
Slit washer
Cam gear q
Cam switch board
C.G. base assembly
Cam R1
Pawl
w
w
J
Cam gear q
Notch
Cylinder
gear
Gear bracket
Cam R1, R2 assembly
Drive unit
x
Pawl
Gear unit
To Next Page
Loading...
