(No.MB011)1-25
3.3.11 Removing the Pickup unit
(See Fig.24 and 25)
(1) Turn the cam gear in the direction of the arrow to move the
pickup unit toward the center.
(2) Extend the guide shaft stopper in the direction of the arrow,
move the guide shaft and pull out as shown in the figure.
(3) Pull out the pickup unit from the joint a.
CAUTION:
When reassenbling, attch the pickup unit to the chassis
base firmly at the joint a.
(4) Release the four joint b on the back on the pickup unit to
remove the CD rack.
Fig.24
Fig.25
Pickup unit
Pickup unit
Chassis base
Guide shaft
Cam gear
Guide shaft stopper
Guide shaft stopper
Guide shaft
Guide shaft
Joint a
Pickup unit
Joint b
Joint b CD rack
Joint b
To Next Page
Loading...
