1-26 (No.MB011)
3.3.12 Removing the CD mechanism board
(See Fig.26)
(1) On the back of the CD mechanism assembly, unsolder the
four soldering c attaching the CD mechanism board, the
spindle motor and the feed motor.
(2) Removing the screw A.
Fig.26
3.3.13 Removing the Spindle motor/Feed motor
(See Fig.27)
• Prior to performing the following procedure,remove the CD
mechanism board.
(1) Form the top side of the CD mechanism assembly, remove
the two screws B and two screws C attaching the spindle
motor and the feed motor respsctively.
Fig.27
A
Soldering c
Spindle motor
Feed motor
CD mechanism board
Soldering c
B
C
Spindle motor
Feed motor
To Next Page
Loading...
