® ® ji
SLEEP
CLOCK/TIMER
SET
DAILY Timer indicator
/
SLEEP indicator _ T T I_1 I_ I_
REC (Recording) Timer indicator _ J ± I _L I
Timer indicator
* When the System is in use, the display shows other items as well.
For simplicity, we show here only the items described in this section.
Three types of timers are available:
DALLY Timer
Use this timer to set wake up everyday to music t'rom any
source, instead of an alarm clock.
NEe (Recording) Timer
Unattended recording of radio broadcasts. You can set tile
starting time and ending time.
SLEEP Timer
Fall asleep and have your System turn off automatically after
a certain length of time.
Setting the Clock
When you plug the AC power cord into the wall outlet, the time in-
dication "AM 12:00" blinks on the display.
You can set the clock whether the System is on or off.
Using the Unit
1 Press the CLOCK/TIMER button.
The hour digit of the time indication blinks on the display.
2 Press the I-,II-_1or I_1_1 button to set the hour.
Pressing the I_,q_lbutton moves the time forwards and pressing
the I-,@,9button moves it backwards. Holding down the button
moves the hour rapidly.
3 Press the SET button.
The minute digits of the time indication blink on tile disphty.
• To return to the hour setting, press tile CANCEL button.
4 Press the _ or _ button to set the minute.
5 Press the SET button.
"CLOCK OK" appears on tile display. Then, tile selected time
is set and the seconds start counting from O.
Fixing the Clock
Usingthe Unit
1 Press the _/I STANDBY/ON button to turn
on the System.
2 Press the CLOCK/TIMER button repeatedly
until clock setting display (time indication)
appears on the display.
Each time you press tile button, display changes as follows:
DAILY _" ON TIME _" REC _" ON TIME _" Clock Setting
display (time indicator) _" Canceled _" (back to the beginning)
3
4
Press the SET button.
The hour digits of the current clock blink on the display.
Follow steps 2 to 5 of "Setting the Clock" men-
tioned above.
• The clock must be correctly set for the timers to work.
• Each setting step must be completed within approx. 30
seconds. Otherwise, the setting is cleared and must be
repeated from the beginning.
• The clock may gain or lose one to two minutes per month.
• If there is a power failure, the clock loses its setting
immediately. "'AM 12:00" blinks on the display and the
clock must be reset.
20
To Next Page
Loading...
Need help?
General
