1-22 (No.MB207)
3.3.3 Removing the belt / motor board / switch board
(See Fig. 48~50)
• Prior to performing the following procedure, remove the CD
tray.
(1) Detach the belt from the pulley on the upper side of the CD
changer unit (Do not stain the belt with grease).
(2) Release the three tabs q and the three tabs r upward on
the backside of the CD changer unit.
(3) Release the three tabs t attaching the switch board.
(4) Unsolder the two soldering on the motor board and remove
the motor.
Fig.48
Fig.49
Fig.50
Belt
CD changer unit
r
g
Switch board
Solder section
Motor board
r
gg
Switch board
t
t
To Next Page
Loading...
Need help?
General
